Full Report:

LAX00TA163 HISTORY OF FLIGHT On April 20, 2000, about 0715 hours mountain standard time, a Hughes OH-6A, N61869, operated by the Department of Justice, U.S. Border Patrol Air Operations, experienced an in-flight control system failure while maneuvering southwest of Green Valley, Arizona. The helicopter crashed in rough terrain and was substantially damaged. The commercial pilot received minor injuries. Visual meteorological conditions prevailed during the public-use flight, which was performed under 14 CFR Part 91. A company flight plan was filed for the flight that originated from Tucson, Arizona, at 0600. The pilot, who has over 19,000 hours of flight time, including 3,326 hours in the accident model of helicopter, reported that seconds prior to losing control of the helicopter, he had been flying about 20 feet above obstacles looking for the footprints of a group of suspected illegal entrants. He suddenly experienced an "unusual vibration in the cyclic control." After the vibration started, the helicopter almost immediately started turning slightly right and descending. The pilot stated that he immediately attempted to stop the turn and descent, but to no avail. HELICOPTER MAINTENANCE INFORMATION The operator reported that the accident occurred during the helicopter's first operational flight following completion of a 300-hour inspection, performed by U.S. Border Patrol mechanics. The inspection was completed on April 19, 2000, and, in part, involved maintenance to the main rotor hub (swashplate assembly). The rebuild of the rotor hub included removal and replacement of several bearings, the main rotor blade pitch control links, the main rotor droop stop ring, and several other components. During this maintenance, the longitudinal link (part number 369A7608) was removed and replaced. WRECKAGE INFORMATION An examination of the wreckage revealed that the longitudinal link that connects the stationary swashplate to the longitudinal pitch mixer bellcrank was observed disconnected at the stationary swashplate. The link's attachment nut and its respective cotter key were not found. In addition, the right-hand link (part number 369A7613) that connects the stationary swashplate to the lateral mixer bellcrank was found fractured. Its respective bolt was missing its required cotter key and the top nut was found backed off and retained on the bolt by approximately three bolt threads. No other evidence of preimpact discrepancies in the flight control system was noted. TESTS AND RESEARCH The operator indicated that an in-flight disconnect of the longitudinal link would result in a complete loss of cyclic control.